Screen protectors are often used for computer screens, games, phones and other electronic devices. It is specially designed for protection and looks like a sticky film that allows it to be placed on the screen so it should be transparent. Sometimes people may notice that there are air bubbles coming out of the screen after placing the protective film, the bubbles on your protective screen are unsightly and visually disturbing. If you are faced with such a problem.
With a little patience and advice, your problem will eventually be solved once the following steps are applied.
If you have not yet applied the protective film :
Turn off your device.
Use a microfiber cloth or strips of adhesive tape on the screen to remove dust from the screen.
Apply your screen protector in the direction that has been provided in the manual, the best way to do this is to use your driver’s license or credit card to slowly smooth and release the bubbles that appear on the screen.
If you want to reapply the screen saver :
Use the edge of your driver’s license or credit card to press down on the bubbles. Do not press too hard if you have an LCD screen. Heat the film slightly with a hair dryer to soften it, but do not overheat the film or the device. Hold it at an angle and work from the center to the edges.
If the credit card has not sufficiently removed the bubbles, you should clean the screen protector. Fill a bowl or tray with equal parts alcohol and water and add a drop of soap. Remove the film and dip it into the bowl. Hold the film and shake off excess liquid. Reapply the above steps.
Smooth the freshly applied film with your driver’s license or credit card. Allow to dry. In 30 minutes, the liquid will evaporate and your shield should be freshly adhered and flat.